Portland Community College | Portland, Oregon

This course is part of a Program designed to meet some of the requirements of the Code of Federal Regulations (CFR) for certification of Aviation Mechanics, and approved by the Federal Aviation Administration (FAA). Upon completion of the Program the student should be able to:

1. Meet the identified Degree and Certificate Outcomes identified in the document found at http://www.pcc.edu/resources/academic/degree-outcome/amt.html as appropriate for coursework level completed.
2. Successfully complete FAA Knowledge testing, in a written test format, as identified in the document:
   FAA-G-8082-3A - AVIATION MAINTENANCE TECHNICIAN—GENERAL, AIRFRAME, AND POWERPLANT KNOWLEDGE TEST GUIDE
3. Successfully complete FAA Knowledge and Skill testing, in an oral and practical test format, as identified in the following documents, as appropriate:
   1. FAA-S-8081-26 – AVIATION MECHANIC GENERAL - Practical Test Standards
   2. FAA-S-8081-27 – AVIATION MECHANIC AIRFRAME – Practical Test Standards
   3. FAA-S-8081-28 – AVIATION MECHANIC POWERPLANT – Practical Test Standards

Upon completion of this course students should be able to:

1. Identify and select aircraft hardware, and the equipment/materials used in performing aircraft cleaning and corrosion control, fluid line maintenance, and non-destructive inspection of ferrous and non-ferrous materials.
2. Use acceptable methods, techniques, and practices during the following maintenance operations: selection and installation of aircraft hardware, use of power tools and shop equipment, fabrication and installation of fluid lines and fittings, non-destructive testing, heat treatment, aircraft cleaning and corrosion control.

Lecture/discussion/demonstration sessions and lab projects, supported by written instructional materials, will present to the student background knowledge needed at entry level for related aviation maintenance employment, and to perform the written, oral, and practical tests which are required for FAA certification of Aviation Mechanics. The assignment of four credit hours to this course indicates that students will be involved with the course content for approximately 120 hours. Class participants will be expected to invest time outside of the official scheduled class hours in their efforts to master the course content. For this course to be creditable toward the FAA authorized Certificate of Completion, the total hours recorded for the course must not be less than 90% of the hours offered during the module (typically 90 hours). Material missed by students during allowed absence will be made available to them in one or more ways, as selected by the instructor. The student is responsible for checking with the instructor following any absence, and for accessing the missed material that is made available.

Evaluation methods include written and oral testing, attendance and class participation, and satisfactory completion of class projects. Evaluation levels will be at least those defined in 14CFR Part 147 Appendices and in this Course Content Guide. A letter grade of “C” (minimum 76%) or higher is required for this course to be creditable toward the FAA authorized Certificate of Completion.

• Fabricate and install rigid and flexible fluid lines and fittings.

• Identify and select cleaning materials. Inspect, identify, remove, and treat aircraft corrosion and perform aircraft cleaning.

• Identify and select appropriate nondestructive testing methods.
• Perform dye penetrate, eddy current, ultrasonic, and magnetic particle inspections.
• Perform basic heat-treating processes.
• Identify and select aircraft hardware and materials.
• Inspect and check welds.
• Demonstrate ability to identify, select, and use correct tools.